Can I remove mold myself?
The EPA's general guidance is that a homeowner can usually handle a moldy area smaller than about 10 square feet, roughly a 3-by-3-foot patch, if the cause is a clean-water problem and nobody in the house has health concerns. Above that, or in any of the cases below, bring in professionals.
| Reasonable to DIY | Leave it to licensed pros |
|---|---|
| Spots on tile, tub caulk, a window frame or a painted hard surface | Growth larger than about 10 sq ft, or spread across several areas |
| Cause is known and fixed (condensation, a drip you repaired) | Mold inside walls, ceilings, ductwork or under flooring |
| Nobody in the house has asthma, allergies or immune issues | Mold after sewage, floodwater or a long hidden leak |
| You can clean and dry it the same day | Mold that keeps coming back |
Texas law adds its own lines. Licensed remediation is required for 25 contiguous square feet or more of visible mold in residential properties with 10 or more units, and licensed remediators must follow the rules on any job. Houses have certain owner exemptions. See mold remediation in Dallas for how the licensed process works.
How to remove small mold spots safely
- Fix the moisture first. Mold returns if the surface stays damp.
- Wear an N95 respirator, gloves and eye protection.
- Scrub hard surfaces with water and detergent, then dry completely.
- Bag and throw away small porous items with growth, like a moldy bath mat or ceiling tile.
- Do not dry-brush or sand moldy material; it sends spores into the air.
- Do not mix cleaners. Never mix bleach with ammonia or acids.
What does not work
- Bleach on drywall or wood. It can lighten the stain but adds water and does not remove growth inside porous material.
- Painting over it. Mold keeps growing behind the paint.
- Air purifiers or ozone alone. They do not remove growth on surfaces.
- Ignoring the cause. If you clean the same spot every month, there is a leak or a humidity problem.
How professionals remove mold
Licensed crews set up containment with plastic sheeting and negative air, wear protective gear, cut out mold-damaged drywall, insulation and carpet, HEPA-vacuum and clean framing and hard surfaces, and dry everything. The process follows the IICRC S520 standard. Specific materials have their own pages: drywall mold removal, bathroom mold removal and attic mold remediation.
Why mold grows so fast in Dallas
Warm temperatures most of the year, humid spells and houses sealed up to keep the AC running give mold what it needs as soon as something gets wet. The Texas Department of Insurance warns mold can start within a day of a leak. Fast drying after any water problem is the best prevention there is; see water damage mitigation.
Not sure whether yours is a DIY job? Call (972) 544-0840 and describe what you see.