Why the HVAC matters so much after a fire
The return side of the system pulls smoky air into the ducts, and the supply side blows it into every room. Soot coats the inside of ducts, the blower and the coil. Every time the system runs, it releases odor and particles. Cleaning walls before the HVAC is cleaned often means cleaning them twice.
What gets cleaned or replaced
| Component | Typical action |
|---|---|
| Filters | Replaced immediately and again after cleaning |
| Registers and grilles | Removed and cleaned |
| Sheet metal ducts | Cleaned under negative pressure with agitation |
| Flexible duct | Often replaced when soot-contaminated; hard to clean fully |
| Blower and housing | Removed and cleaned |
| Evaporator coil | Cleaned; heat-damaged coils replaced |
| Internal insulation | Replaced if contaminated |
Until it is cleaned
- Keep the system off if possible.
- If you must run it, install a new filter and cover supply registers with filter material, changing it often.
- Do not run the system during demolition or soot cleaning.
Dallas timing
Running without AC in a Dallas summer is not realistic for long. A good provider prioritizes HVAC cleaning so the system can safely return to service, and may bring temporary cooling for occupied homes or businesses.
Ducts in the attic
Most Dallas homes have ductwork in the attic. If the fire or smoke reached the attic, ducts there may be damaged by heat, soot or water and are often replaced along with insulation.
HVAC work is a key step in smoke odor removal and smoke damage restoration. For mold in HVAC systems instead, see HVAC mold cleaning. Call (972) 544-0840.