Phone line open 24/7 for Dallas water emergencies📍 Serving Dallas TX & Surrounding Areas · (972) 544-0840
Dallas Pro Water Restoration
Electrical fires · Wiring · Hidden damage

Electrical Fire Damage Restoration in Dallas

Electrical fires often start where you cannot see them: inside walls, in the attic, at the panel. The visible damage may be the smallest part of the job.

Short answerElectrical fire damage restoration combines licensed electrical repair with fire and smoke restoration. Damaged wiring, devices and panels are replaced by an electrician, walls and ceilings are opened to find hidden damage, and smoke, soot and odor are cleaned throughout the property.
Do not restore power yourselfAfter an electrical fire, keep the power off until a licensed electrician has inspected the system. Oncor handles service to the meter; everything after the meter is the property owner's electrician's job.

Common causes of electrical fires

  • Overloaded circuits and extension cords
  • Damaged or aging wiring, including older aluminum branch wiring in some 1960s and 1970s homes
  • Loose connections at outlets, switches and breakers
  • Faulty appliances, space heaters and chargers
  • Damage from rodents chewing wires in attics
  • Recessed lights covered by insulation

Why hidden damage matters

Wire insulation can melt along a run far from where flames were seen. Heat travels along conductors and inside wall cavities. Restoration crews open walls and ceilings around the fire to check framing and wiring, and the electrician decides what must be replaced.

The restoration sequence

  1. Electrician inspects and makes the system safe.
  2. Board-up and water removal if needed.
  3. Open walls and ceilings in the fire area to expose damage.
  4. Remove burned materials and clean framing.
  5. Electrician replaces damaged wiring, devices or panel; permits and inspection.
  6. Smoke and soot cleaning throughout; see smoke damage restoration.
  7. Seal, insulate, drywall and finish.

Electronics and appliances

Devices on the affected circuit may have been damaged by surges or heat, even if they look fine. Have valuable electronics checked before use. Smoke residue inside devices can cause failures later; see content cleaning and restoration.

Insurance notes

Accidental electrical fires are generally covered. Rebuilding may require bringing wiring up to current code, which can involve ordinance or law coverage limits in your policy. Keep the electrician's report with your claim.

Call (972) 544-0840 to get connected with a restoration provider. For the full process, see fire damage restoration in Dallas.

FAQ

Electrical Fire Damage Restoration: common questions

Is it safe to stay in the house after a small electrical fire?

Only after a licensed electrician has inspected the system and confirmed it is safe, and smoke levels are acceptable. Keep the affected circuit off until then.

Why do walls need to be opened after an electrical fire?

Heat can damage wiring and framing inside walls well beyond the visible burn. Opening walls is the only way to confirm.

Who restores power after an electrical fire?

A licensed electrician repairs and inspects the home's wiring. Oncor handles the service up to the meter if it was disconnected.

Water still spreading? Get a Dallas restoration crew moving.

One call connects you with an independent local company that handles extraction, drying and repairs. The line is open around the clock.

Call (972) 544-0840
Call Now for 24/7 Help