The first 48 hours after a house fire
Secure the property, get the water out, and stop soot from setting into surfaces. Fire damage gets worse after the fire is out: water from the hoses soaks into the house, acidic soot etches metal, glass and grout, and an open roof or broken window invites rain and theft.
- Wait for the all-clear. Do not go back in until Dallas Fire-Rescue or the fire marshal releases the property.
- Utilities. Do not turn power, gas or HVAC back on until Oncor, Atmos Energy or a licensed electrician says it is safe.
- Call your insurer and get a claim number. Ask about additional living expense coverage if you cannot stay in the home.
- Board-up and tarp. Openings in walls, windows and roof are covered the same day to keep weather and people out.
- Water removal. Firefighting water is extracted and drying starts, just as with any other water extraction job.
- Document. Photograph every room before cleanup starts. Make a contents list as you go.
Water damage after firefighting
People are surprised by how wet a house is after a fire. Hose lines put a lot of water into walls, ceilings and floors, and it runs to the floor below and into rooms the fire never touched. Treat it like any other water loss: extraction, moisture mapping, drying and verification. Left alone for a few days, it adds mold to a fire claim. Our water mitigation and structural drying page explains how drying is measured.
Types of smoke and soot, and why they clean differently
| Residue | Typical source | What it is like |
|---|---|---|
| Dry smoke | Fast, hot fires burning paper and wood | Powdery, easier to remove, but gets into cracks |
| Wet smoke | Slow, smoldering fires with plastics and rubber | Sticky, smeary, strong odor |
| Protein residue | Kitchen fires, burned food | Nearly invisible film, very strong odor, discolors paint |
| Fuel or oil soot | Furnace puffbacks, oil-based fires | Dense, greasy, hard to clean |
Wiping soot with a damp rag is the most common mistake. It smears oily residue into paint and grout. Crews usually start with dry chemical sponges and HEPA vacuums, then move to the right cleaner for the residue.
Kitchen fires and electrical fires
Kitchen fires are the most common house fires. Even a small stovetop fire coats the kitchen, and often the whole house through the HVAC, in protein residue you can smell long after it looks clean. Cabinets, the range hood, ceiling and ductwork usually need cleaning.
Electrical fires often start inside walls or in the attic. Even when the visible damage is small, wiring in the area must be inspected by a licensed electrician before the power goes back on. Burned wiring is replaced, not cleaned.
Smoke odor removal
Smoke odor removal works only after cleaning. The sequence is:
- Remove burned and charred materials. Odor lives in them.
- Clean soot from every surface, including inside cabinets, closets and light fixtures.
- Clean or replace HVAC filters and get ductwork cleaned so the system does not recirculate odor.
- Deodorize with methods matched to the job: thermal fogging, hydroxyl generators that can run in occupied spaces, or ozone treatment in unoccupied spaces only.
- Seal surfaces that still hold odor, like framing in the burn area, with an odor-sealing primer before rebuilding.
The IICRC standard for this work is S700. Ask the provider how it will verify odor is gone before walls are closed.
Contents cleaning and pack-out
Furniture, clothing, electronics, documents and keepsakes are often packed out, cleaned off-site and stored until the house is ready. A good pack-out includes an inventory with photos, which doubles as your contents list for the claim. Upholstery and carpet with smoke odor can often be cleaned; items that burned or melted cannot.
Structural fire damage repair
Charred framing is evaluated and either cleaned and sealed or replaced. Roof sections, drywall, insulation, wiring, plumbing and HVAC in the burn area are typically rebuilt. Rebuilds in Dallas need City of Dallas building permits; Highland Park and University Park have their own permit offices. Your provider or general contractor should pull permits, not you.
Fire claims in Texas: a few things to know
- Additional living expenses. Most homeowners policies pay reasonable extra costs to live elsewhere while the home is repaired. Keep receipts.
- Your deductible is yours. Texas law bars contractors from waiving or absorbing it.
- Contractors cannot adjust your claim. If you want someone negotiating for you, hire a licensed public adjuster.
- Do not throw out damaged items before the adjuster has seen them or you have photographed them.
Fire, smoke and water damage often show up together. For the water side of a loss, see our guide to water damage restoration in Dallas, TX. If the fire or the water used to fight it led to mold, see mold remediation. Big homes with lots of finishes and contents, like those in Preston Hollow, benefit most from a careful pack-out.
When the fire department releases the property, call (972) 544-0840 for board-up, water removal and smoke cleanup.